First of all, You put a microchip on the thing you want do do it on, Then you put a controlinator in the top left corner and tweak it to "receiver" then go to the triangle button on the controlinator, grab its wire and put it IN THE MIDDLE OF THE CHIP DO NOT CONNECT IT!!!! you should see a little thing on your chip with a > on it then put a normal mover on the door and set "up/down speed" to 0 and the "left/right speed" to 1 then put the attach the button with a > on it to the mover, after this close all the chips and controlinators and walk in front of the door and press triangle, the door should move to the left or right, if not, contact me or do the tutorial again

is this those GRAB doors that you just grab it and it opens and closes?

A ok Darkrodent it would have helped if you would have mentioned what kind of door you were talking about. The door he is talking about is the one that you have to change layer to go thru.

This are the grab doors


The grab doors can use that logic but it would have to be with R1.

I usually put an invisible sticker panel or hologram with a microchip and in the micro chip, material tweaker set to grabbable, and with a grab sensor. That is for the "doorknob"

On the door a microchip, with two in/ out movers set opposite of each other (One moves in and the other moves out). Place a selector, and connect one of the selectors outputs to one of the In/Out movers and the other output to the other mover. Open the microchip for the "doorknob." And grab the output of the grab sensor and set it to the vertical input in the selector the one that is not on the sides but on the buttom of the selector. ( I cant remember it off the top of my head.)

So now place the "doorknob" in the middle of the door so that it can be grabbed from both sides and there you have a door that moves in and out.

If I have something that needs to be corrected please do so. I will make a video soon.